Bearing installation instructions.

Apr 14, 2021 | News

Thrust roller bearing.

  1. When installing the bearing, clean the bearing oil seal and clean the high quality lubricating oil.
  2. When the bearing is installed, it shall be uniform and not hammer.
    Such as the interference fit is larger, should put the bearing into the mineral oil in heated to 90 ° to 100 °, the installation immediately.
  3. The storage room for bearing should be clean, clean and relative humidity not exceeding 65%.
  4. The stock bearings should be cleaned and coated once every other year, and the oil seal packaging is kept in good condition.

When using the bearing, it should have a good sealing and dustproof device, Split cylindrical roller bearing and should check the working condition frequently.

Deep groove ball bearing

  1. When mounting the bearing, the force should be evenly China Copper split roller bearing distributed, and cannot be directly hammered.
    Such as: cooperate with interference is bigger, bearing should be placed on automatic temperature control of air heating furnace or oil furnace, heating temperature control strictly under 120 °.
  2. Equipped with nylon cage bearing to under – 40 °, 120 ° long-term continuous stable work, the work should not be more than 4 hours at 150 °, short peak temperature should not exceed 180 °.
  3. The storage of the bearing should be cleaned, dry and not stored in a warehouse with chemical products. The relative humidity should not exceed 65%, and the bearing shall not be stored on the floor.
  4. The inventory bearing should be cleaned again every other year for anti-rust packaging.

Rolling bearing

  1. When mounting the SKF bearing, the force should be evenly distributed, and cannot be directly hammered.
    Such as: cooperate with interference is bigger, bearing should be placed on automatic temperature control of air heating furnace or oil furnace, heating temperature control strictly under 120 °.
  2. Equipped with nylon cage bearing to under – 40 °, 120 ° long-term continuous stable work, work should not be more than 4 hours at 150 °, the transient temperature peak of up to 180 °.
  3. The storage of the bearing should be cleaned, dry and not stored in a warehouse with chemical products. The relative humidity should not exceed 65%, and the bearing shall not be stored on the floor.

Angular contact ball bearings.

  1. When mounting the bearing, the force should be evenly distributed, and cannot be directly hammered.
    Such as: cooperate with interference is bigger, bearing should be placed on automatic temperature control of air heating furnace or oil furnace, heating temperature control strictly under 100 °.
  2. Equipped with nylon cage bearing to under – 40 °, 120 ° long-term continuous stable work, the work should not be more than 4 hours at 150 °, the transient temperature peak of up to 180 °.
  3. The storage of the bearing should be cleaned, dry and not stored in a warehouse with chemical products. The relative humidity should not exceed 65%, and the bearing shall not be stored on the floor.